THE CUTTING EDGE
Digital Workflow for 3D-Printed Intraoral Plates with Attached Nasal Stents for Nasoalveolar Molding in Cleft Lip and Palate Patients
Drs. Abd-El-Ghafour and Hegab offer a fully digital workflow for nasoalveolar molding for patients with cleft lip and palate. This approach enables treatment to be completed in as few as three office visits, reducing the burden on patients and parents during the neonatal period.
This article can only be viewed by JCO subscribers. Subscribers should log in below. You can purchase a subscription to JCO for as little as $223 a year worldwide. You can also purchase access to the entire JCO archive for 1 or 30 days ($30 or $70), or for $10 just this article for one year.
Please log in to your account to proceed. If you do not have an account, please create one.
Need Help?
Dynamic verses Static IP
Please select whether you have a dynamic IP address or a static IP address. A dynamic IP address can change over time while a static IP will never change. You may need to contact your IT administrator to find this out. If you don't have access to this information, you should select the option that you are using a dynamic IP address.
Note: If you do select dynamic IP address, you must have cookies enabled for your browser.
